Advertisement
Quick Links
2018
Aluminum Tank & Tank Accessories, Inc.
2702-B N. Nichols, Fort Worth, TX 76106
800-773-3047 * 817-378-8455
www.ATTAtank.com
attatank@gmail.com
FREEDOM FILL AUXILIARY SYSTEM
Gauge & Switch Console
FILL OUT WARRANTY CARDS FIRST BEFORE
INSTALLATION. WARRANTY WILL BE VOID IF WE
DO NOT RECEIVE WARRANTY CARD.
NOTE: Visit our webpage at www.attatank.com, for a helpful instructional video of an installation.
Follow us on Facebook:
www.facebook.com/aluminumtanks
SAFETY PRECATIONS:
*READ ENTIRE INSTALLATION INSTRUCTION PRIOR TO INSTALLATION.
*Use proper eye protection during any installation.
*Work in a well ventilated area.
*Do not connect or disconnect any wires with ignition in the on position
*Do not modify or substitute any component provided with installation kit.
*Any questions regarding installation, please contact your dealer.
*Warranty will be void if installation is not followed as per installation instructions.
1
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for ATTA FREEDOM FILL
Summary of Contents for ATTA FREEDOM FILL
- Page 1 Aluminum Tank & Tank Accessories, Inc. 2702-B N. Nichols, Fort Worth, TX 76106 800-773-3047 * 817-378-8455 www.ATTAtank.com attatank@gmail.com FREEDOM FILL AUXILIARY SYSTEM Gauge & Switch Console FILL OUT WARRANTY CARDS FIRST BEFORE INSTALLATION. WARRANTY WILL BE VOID IF WE DO NOT RECEIVE WARRANTY CARD.
- Page 2 EXAMPLE OF MOUNTING POSITION OPTIONS SHOWN BELOW: 2. Place the Freedom Fill Controller Box under the instrument panel, (It may be necessary to remove the dash panel). This can be done by using two zip-ties to attach the controller to a factory harness or bracket.
- Page 3 Examples of 12 volt ignition power sources. (Examples only, due to variations in vehicles, see owner’s manual.) 2017 Ford – w/ upfitter switches = Brown wire near under hood driver side fuse panel. (To locate wire, reach down behind the under fuse panel. You should be able to feel a group of blocked of wires. Pull the wires up and find the solid brown wire).
- Page 4 7. Route the remaining wires (White, Black, Blue, and Yellow “from fuel gauge”) through the fire wall and route the wires along the frame rail. Insure the wires do not come in contact with any moving parts. Use a small grommet or use a rubber boot when routing wires through firewall to insure wires will not chaff and create a short.
- Page 5 *Note: Vent Line Adaptor may differ than picture shown. (Pictures below shows Factory Fill Neck removed from truck. Example Only. The Factory Fill Neck does not need to be removed for installation of the Vent Line Adapter.) ((Installer Tip: When cutting a metal fill vent line, place a magnet on the line to catch any metal shavings.)) **Warning: When mounting the Vent Line Adaptor, be sure that the position of the factory fill vent line, does not allow the line to retain fuel.
-
Page 6: How The System Works
½ a tank, the system will remain off until the factory tank reaches the appropriate level of approx ½ a tank. If the truck or Freedom Fill System is shut off during fuel transfer, it will not turn back on until the factory tank reaches approx half a tank. - Page 9 If a fuel tank or headache rack needs to be repaired, it shall be done at a “Repair and Return” only, unless deemed un-repairable by ATTA, Inc discretion. If a part must be replaced, ATTA, Inc. will furnish the replacement part on a “Return and Replace basis” only. ATTA will pay the established warranty labor rates, listed below, once authorization has been established.
Need help?
Do you have a question about the FREEDOM FILL and is the answer not in the manual?
Questions and answers