Advertisement
The purpose of this guide is to give a brief guide to the common troubleshooting steps we
come across. While this will not cover every problem that may occur, it will cover the most
common problems.
Suggestion: Make sure you have followed all the steps properly in the instruction. Make sure
you are using only the parts supplied to you that came with the Freedom Fill Installation Kit.
The fuel system may or may-not work with substituted parts.
•
Does the light on the switch turn on for approximately 5 seconds and shut off?
o
NO: (Light stays on always) Go to #1
o
YES: Go to #2
1. Check the negative wire of the pump to ensure it is connected only to the black wire
coming from the Freedom Fill Computer module, not to chassis ground.
o
Pump grounded to frame:
o
Yes: Pump should not be grounded to frame, (-) wire to Black wire of computer
harness.
o
No: Inspect harness plug of the computer module and ensure no wires have been
pulled loose. If the harness is bad, replace harness. If the harness is correct,
replace computer module.
2. Make sure you are on the correct factory sending unit with a good connection with the
blue wire from the Freedom Fill Auxiliary System wiring harness.
o
Purple-04-14 GM/Chevrolet
o
Blue w/ Purple Strip 2015+ Gm/Chevrolet
o
Yellow with purple stripe-2008-current Ford
o
Yellow with white stripe 88 to 07 Ford front tank
o
Blue with black stripe 03 to 05 Dodge
o
Blue with white stripe-98-02 & 06-Current Dodge)
(See owner's manual due to variations of truck wiring).
o
o
YES: Go to #4
o
NO: Attach Freedom Fill Blue Wire onto correct sending unit wire
3. Check the voltage on the blue wire at the computer module. Ensure you are getting the
correct reading of voltage in comparison to the level of the factory tank. If you do not
know what the voltage should read, please call us at
reading and the level of the factory tank.
Freedom Fill Troubleshoot
Pump Will Not Shut Off
800-773-3047
with the voltage
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for ATTA Freedom Fill
Summary of Contents for ATTA Freedom Fill
- Page 1 Suggestion: Make sure you have followed all the steps properly in the instruction. Make sure you are using only the parts supplied to you that came with the Freedom Fill Installation Kit. The fuel system may or may-not work with substituted parts.
- Page 2 3047 with your computer module serial number. Pump Will Not Turn On 1. Make sure the switch for the Freedom Fill System is on the “ON” position. Does the light on the switch turn on? YES: Go to #3 NO: Go to #2 2.
- Page 3 Note: Do not leave the negative wire connected to Chassis Ground. The Negative must be connected to the black wire in the Freedom Fill Computer Harness. B. If the pump still does not turn on, then the pump may need to be replaced C.
- Page 4 3. Make sure the white wire from the Freedom Fill Switch is to the (+) “Positive” side of the pump. Make sure the black wire is to the (-) “Negative” Side of the Pump. 4. Make sure no hoses have a sharp bend or kink in the line.
- Page 5 3. Check you have the correct computer module to your truck. 4. Replace computer module. If you are experiencing a problem that is not addressed in the steps above or the troubleshooting steps could not resolve, please call ATTA at 1-800-773-3047.
Need help?
Do you have a question about the Freedom Fill and is the answer not in the manual?
Questions and answers