Advertisement
Wall or Ceiling Mounted Location
To install the mounting bracket on a hollow wall or ceiling, use the bracket to
position and drill holes for the toggle screws supplied, using a 3/8-inch drill
bit. Insert the bolt through the holes in the bracket, then screw on the toggle
piece. Insert bolt and toggle through the hole. The toggle will open on the
other side of the hole. Turn the bolt until the bracket is secure.
Install Mounting Bracket on
Wall
Attach Access Point to Bracket
If the access point is attached to a ceiling or to a wall near the ceiling, it
should be positioned with the antenna on the bottom (as shown below).
If the access point is mounted at a lower point on the wall, it should be
positioned with the antenna on the top (see the illustration for Desk or Table
Top location, page 9; the access point is designed so that it can be attached
to the mounting bracket hooks in either orientation).
10
Install Mounting Bracket on
Ceiling
Advertisement
