Advertisement
V
Press
/
V
key for more than 3 seconds. can enter / quit from the
V
V
second grade parameters setting
Input Signal Selection :
mA V mV Rt Pt Tc
SET
Low Display Setting
Range : –1999~9999
SET
Input High Display Setting
Range : –1999~9999
SET
Decimal Point Setting : 0~3 Stands
for 0000, 000.0, 00.00 and 0.000
SET
AL1 Hysteresis Range : ± 50.0
SET
AL2 Hysteresis Range : ± 50.0
SET
AL3 Hysteresis Range : ± 50.0
ANKOM/MAN/IND-36
8
Page -08/11
•
Parameter Setting :
1.
Alarm Setting : In the displaying estate, press and hold SET
key for more than 3 seconds, enter alarm mode parameters
setting menu. Press << / RST key. LED flashes. Press / key
to modify, and then press SET key to confirm. Press SET key
to read the following parameters one by one.
2.
Rate Setting : In displaying estate, press <</RST key and
LED flashes, then you can modify the value by Up and Down
key. The factory setting is 1.00. Once the user want to set it to
be other value, then PV=Rate × (USP-LSP) + LSP USP
means Up limit, LSP means Down limit.
3.
Zero Point Clear : In the displaying estate, without key
operation, when the input zero point, press and hold
<</RST key for more than 2 seconds. It is for the sensor
zero point clear.
4.
The instrument will return to the measuring estate without any
operation for 25 seconds.
•
Special Function :
The instrument can be input by up to 2 signals, the up and
down LED can display the measuring value. The instrument
can calculate the two input value, so it also can be used as a
watt meter.
5
ANKOM/MAN/IND-36
Page - 05/11
Advertisement
