Advertisement
Quick Start Guide
INCA Repeater
The most important thing we build is trust
INCA Repeater Remote Commands
0
On
1
Off (sleep mode)
2
N/A
3
N/A
INCA Repeater Software Configuration
To configure the INCA Repeater software:
1. Connect the INCA Repeater to a computer containing the INCA Repeater Setup Utility software.
2. The power LED will illuminate Orange to indicate the INCA Repeater is receiving power via the USB.
Note:
Connecting external power to the INCA Repeater is not required when programming the INCA Repeater. The INCA Repeater is
powered via USB for software configuration.
3. Select the Operating Mode in the Operation Tab - (Repeater, Receiver (RX) only, or Transmitter (TX) only).
Note:
The specified operating mode will determine what options and settings are available when configuring the INCA Repeater.
1
4. Set the Activate Condition in the Operation Tab.
Note:
The RSSI activate condition is only available when operating the device in Repeater mode.
5. Set the Audio Path options in the Operation Tab.
Note:
Two audio paths exist with-in the INCA Repeater. One for on-site listening (repeater location) and the other for the rebroadcasted
signal. The operating mode determines which configuration options for the audio path are available.
6. Set the required Frequencies, Volume, and Power level in the Main Tab.
Note:
If the user is employing the device in Repeater mode the recommended technique is to invert the RX frequencies with the TX
frequencies ensuring the paired TX and RX frequency contains at least 100 MHz of frequency separation between paired channels.
4
80011422
4
N/A
5
N/A
6
Channel 1
7
Channel 2
2
5
Sept. 2014 - Version 1.4.1
8
Channel 3
9
Channel 4
A
Power Level 1
B
Power Level 2
3
6
C
Power Level 3
D
Power Level 4
E
N/A
F
N/A
www.cobham.com/tcs
Advertisement
Table of Contents
Related Manuals for COBHAM INCA Repeater
Summary of Contents for COBHAM INCA Repeater
- Page 1 5. Set the Audio Path options in the Operation Tab. Note: Two audio paths exist with-in the INCA Repeater. One for on-site listening (repeater location) and the other for the rebroadcasted signal. The operating mode determines which configuration options for the audio path are available.
- Page 2 4. Connect a 12 V DC power supply to the 12 V DC IN Lemo jack. Note: Do NOT connect the INCA Repeater directly to AC power. The INCA Repeater supply voltage range is 10.0 V to 15.6 V DC. Only use the included power supply or an external battery.
- Page 3 FCC approval only applies to the VHF version of the INCA Repeater. www.cobham.com/tcs 80011422 Sept.
Need help?
Do you have a question about the INCA Repeater and is the answer not in the manual?
Questions and answers