Control Functions; Starting The Appliance In Stand-Alone Mode; Starting The Appliance With An External Timer Or Coinbox; Pause Mode - HAPRO Luxura V6 User Manual

Control functions

The appliance is set up for standard use with an external timer or a coinbox. If the appliance must function without the external timer or coinbox,
i.e. with an internal timer, the required tanning time will have to be adjusted according to the following procedure.

STARTING THE APPLIANCE IN STAND-ALONE MODE

+

STARTING THE APPLIANCE WITH AN EXTERNAL TIMER OR COINBOX

Note:
If an external timer or coinbox does not have a 'remote start' function and instead the appliance must be started with
the start/stop button, this can be configured by your dealer.

PAUSE MODE

6
Press start/stop
The display shows the maximum tanning time.
The LEDs above plus/minus flash red.
Set the desired time.
Press start/stop to confirm the set time.
The tanning lamps now switch on.
The timer counts down.
The appliance will be started automatically if there is no 'remote start' present on the external timer or coinbox.
If this is present, the LED above the start/stop button will flash green. The tanning session begins as soon as the
start/stop button is pressed. The timer counts up.
Press start/stop. The lamps are switched off. NOTE! The session time continues counting.
Press start/stop again to restart the tanning session.
In stand-alone mode the session can be ended at any time by holding the start/stop button for three seconds.