Tanning Appliance Settings; Parametermenu; Parameters - HAPRO Luxura V6 User Manual

Tanning appliance settings

PARAMETERMENU

+
+

PARAMETERS

The sunbed can be set to your preferences by changing the parameters shown here. The parameters that are not shown in the table may only be changed by
your dealer.
+
Note:
If no button is pressed for one minute, you automatically return to the stand-by screen.
DISPLAY
Unit
1
Start time (minutes)
1.
Maximum time
2.
Special mode
3.
Pin code
4.
Usefull life lamps
5.
Clean time (minutes)
6.
Bodycooler
2
Bodycooler at start
1.
Xsens
3
Xsens available
1.
Xsens at start
2.
SoundAround
4
My MP3 input present
1.
Hold the body cooling and minus buttons for ten seconds.
Enter the PIN code; it is set to 000 by default.
You can change the value of the digit with plus and minus.
Press the body cooling button to proceed to the next digit.
Press start/stop to confirm the PIN code.
Navigate to the desired submenu with plus and minus, and press start/stop to confirm your choice.
Press the body cooling button to return to stand-by.
Navigate to the desired parameter menu with plus and minus, and press start/stop to confirm your choice.
Press the body cooling button to return to the parameter menu. Use plus and minus to change the value.
Save the new value with start/stop. You now return to the submenu.
Press the body cooling button to cancel the new value. You now return to the submenu.
0 = Coin unit / 1 - maximum time = Stand alone
Time at which the decorative lighting is switched on
1 = Restore factory settings / 6 = Reset TL hour meter
Unique code for entering the parameter menu
Step Size: 100 hours. 0 = no message
The length of time the display is switched off for cleaning
Speed of the body cooler at the beginning of the session
Xsens scent at the beginning of the session (0 = off )
DEFAULT
0
30 (min.)
0
000
0 (hours)
1 (min.)
1
Off
Off
On
11