Setting The Clock; Setting A Delayed Start Time - Insignia NS-CM10SS9 User Manual

NS-CM10SS9_18-0494_MAN_V3_EN.fm Page 7 Friday, August 24, 2018 9:03 AM
Place the thermal carafe with the lid closed on the warming plate. Make sure
5
that the center of the carafe aligns with the bottom of the funnel.
Plug the power cord into a power outlet.
6
Press the ON/OFF button. The ON/OFF indicator lights green and your coffee
7
maker starts brewing.
Note: Some of the water you add to the water tank is absorbed by the dry
coffee, so the amount of coffee that results from the brewing cycle is always
somewhat less than the water you added.
To pause brewing, press the ON/OFF button. The ON/OFF indicator turns off.
8
To start brewing again, press the ON/OFF button again.
When the brewing cycle is complete, wait about a minute until the dripping
9
stops, then remove the thermal carafe and serve the coffee.
When brewing is complete, your coffee maker automatically switches to
standby mode.
Notes:
• You can remove the thermal carafe and pour a cup of coffee while your
coffee maker is brewing. Your coffee maker automatically stops dripping for
30 seconds. Make sure that you put the carafe back on the warming plate
before dripping starts again.
• During the brewing process, you cannot use the AUTO/PROG, HOUR, and
MINUTE buttons.

Setting the clock

You can set the clock to the current time. If you plan to use the delayed brewing
feature, you need to set the clock.
Plug the power cord into a power outlet. AM 12:00 appears on the display.
1
Repeatedly press the MINUTE button to set the minutes and the HOUR
2
button to set the hour. If the current time is after noon, make sure that you
press the HOUR button repeatedly until PM appears on the display, then
continue using the HOUR button to set the correct hour.

Setting a delayed start time

You can prepare your coffee maker for brewing, then set a delayed start time.
Make sure that you have set the clock. See Setting the clock on page 7.
1
Press the AUTO/PROG button. The AUTO/PROG indicator lights red and
2
flashes.
Repeatedly press the MINUTE and HOUR buttons to set the delayed start
3
time. Make sure that the correct AM or PM indicator appears in the display.
Press the AUTO/PROG button to save your setting. The AUTO/PROG indicator
4
turns off.
Programmable Stainless Steel Coffee Maker with Thermal Carafe
www.insigniaproducts.com 7