Safety Notes; Important Notes; Functions - Trix Re 14 Green Cargo Manual

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 8

Safety Notes

• This locomotive is only to be used with the operating
system it is designed for.
• Analog max. 15 volts DC, digital max. 22 volts AC.
• This locomotive must not be supplied with power simulta-
neously by more than one power pack.
• Please make note of the safety notes in the instructions
for your operating system.
• The feeder track must be equipped to prevent inter-
ference with radio and television reception, when the
locomotive is to be run in conventional operation. The
611 655 interference suppression set is to be used for this
purpose. The interference suppression set is not suitable
for digital operation.
• Do not expose the model to direct sunlight, extreme
changes in temperature, or high humidity.
• WARNING! Sharp edges and points required for operation.

Important Notes

• The operating instructions and the packaging are a com-
ponent part of the product and must therefore be kept as
well as transferred along with the product to others.
• Please see your authorized Trix dealer for repairs or spare
parts.
• http://www.maerklin.com/en/imprint.html
8

Functions

• Built-in electronic circuit for operation with a conventi-
onal DC power pack, Trix Systems or NMRA DCC digital
systems.
• Automatic system recognition between digital and analog
operation.
• The full range of functions is only available under Trix
Systems and under DCC.
• Built-in headlights that change over with the direction of
travel. They can be turned on and off in digital operation.
• The locomotive cannot be switched to operation from
catenary.
• Minimum radius for operation is 360 mm / 14-3/16".
Notes on digital operation
• The operating instructions for your central unit will give
you exact procedures for setting the different parame-
ters.
• The values set at the factory were selected to guarantee
the best possible running characteristics.
• The setting done at the factory does not permit operation
with opposite polarity DC power in the braking block.
If you want this characteristic, you must do without
conventional DC power operation (CV 29 / Bit 2 = 0).
• Controllable Functions:
– f0: Direction-dependent Headlights
Warrenty
• The warranty card included with this product specifies
the warranty conditions.

Advertisement

Table of Contents
loading

This manual is also suitable for:

22807

Table of Contents