Safety Notes; General Notes; Functions; Spare Parts - Trix 21518 Manual

1. Safety Notes

• This locomotive is to be used only with an operating system designed for it.
• Use only switched mode power supply units and transformers that are designed for your local power
system.
• This locomotive must never be supplied with power from more than one power pack.
• Pay close attention to the safety notes in the instructions for your operating system.
• The feeder track must be equipped to prevent interference with radio and television reception, when
the locomotive is to be run in conventional operation. The 611 655 (inclosed) interference suppression
set is to be used for this purpose. The interference suppression set is not suitable for digital operation.
• The wire used for feeder connections to the track may only be a maximum of 2 meters / 78 inches long.
• Do not expose the model to direct sunlight, extreme changes in temperature, or high humidity.
• WARNING! Sharp edges and points required for operation.

2. General Notes

The operating instructions are a component part of the product and must therefore be kept in a safe place
as well as included with the product, if the latter is given to someone else.
Please see your authorized Trix dealer for repairs or spare parts.
www.maerklin.com/en/imprint.html
No warranty or damage claims shall be accepted in those cases where parts neither manufactured nor approved by
Trix have been installed in Trix products or where Trix products have been converted in such a way that the non-Trix
parts or the conversion were causal to the defects and / or damage arising. The burden of presenting evidence and the
burden of proof thereof, that the installation of non-Trix parts or the conversion in or of Trix products was not causal to
the defects and / or damage arising, is borne by the person and / or company responsible for the installation and / or
conversion, or by the customer.

3. Functions

• This model is designed for operation with H0 2-rail DC systems (track according to NEM standards)
with conventional DC power packs.
• Analog 14 volts DC, digital 22 volts AC.
• This locomotive comes equipped with a Trix connector for digital operation and can have the Trix loco-
motive decoder 66839/66849 installed in it.
• Trix motor vehicles must not be operated on digital systems without an built-in engine decoder (Motor
can be damaged!).
4