Troubleshooting - Kobra AF+1 Operating Instructions Manual

If you have any problems with your shredder, check the symptoms and remedies described below.
If you are unable to solve the problem this way, contact your nearest Kobra dealer.
Do not open the head of the shredder to attempt to repair it yourself. You could get a serious electric shock and
invalidate your warranty
PROBLEM
The shredder fails to
start
The shredder never
stops
Significant reduction of
shredding capacity
Documents are not
drawn in and shredded
Compliant with - directive LVD 2014/35/EU
- directive 2011/65/EU RoHS
- directive 2004/108/EC EMC
The manufacturer ELCOMAN SRL
VIA GORIZIA,9
hereby declares that the KOBRA shredders listed below are compliant with the standards of directive LVD 2014/35/EU
- Kobra series: Kobra AF.1 , Kobra AF+1
Standards applied are :
EN 60950-1:2006 / A11:2009 / A1:2010 / A12:2011 / A 2:2013
EN 55014-1 :2006+A1 :2009+A2 :2011
EN 55014-2 :1997+A1 :2001+A2 :2008
Bovisio Masciago, 30.03.2017
A.DE ROSA
T O
EchnicAl fficE
SIGNS
- The light (G) does
not come on
- Red light (I) comes
on
- Light (G) comes on
- Light (G) on and
cutters in operation
- Capacity is less than
the declared capacity
- Documents remain
in the paper feeder
tray
DECLARATION OF COMPLIANCE WITH EC STANDARDS
20813 BOVISIO MASCIAGO (MI) – ITALY-
TROUBLE-SHOOTINg
CAUSE
- Switch position ( H )
- Power cable not properly
connected
- No power
- Door (C) not closed properly
- Bag full
- Motor in heat protection mode
Material and/or dirt deposited
on or between the photocells
- Cutters dirty or adhesive on
blades
- Dirty belts covered in paper
dust
EN 61000-3-2 :2014
EN 61000-3-3 :2013
10
ACTION
- Turn switch to the position (I)
- Check that the cable is plugged
in properly
- Check that socket is switched on.
- Close the door properly
- Empty bag
- Wait 15 minutes for motor to
cool down
Remove the deposit from or free
the photocells
Clean the photocells with a brush
- Carry out maintenance by
inserting a sheet of paper
sprinkled with lubricant
-
Turn the belts manually and
clean them carefully with a damp
cloth