Cisco WAP581 Quick Start Manual page 5

Insecure mounting might damage the device or cause injury. Cisco is not
W
ARNING
responsible for damages incurred by insecure wall or ceiling mounting.
Determine where you want to mount the device. Verify that the surface is
S 1
TEP
smooth, flat, dry, and sturdy.
Drill two pilot holes into the surface 2.75 inches (70 mm) apart for your Cisco
S 2
TEP
WAP device.
Insert a screw into each hole, leaving a gap between the surface and the base
S 3
TEP
of the screw head.
Place the upper slots of the bracket over the screws, adjust the screws
S 4
TEP
accordingly, and slide the bracket down until the screws fit snugly into the
slots.
Using the bracket as a template, drill two more holes for the lower screws.
S 5
TEP
Insert a screw into each lower hole.
S 6
TEP
Cisco WAP125 Quick Start Guide 5