Operation - Sonix 4 Ultrasonics SR236 User Manual

Opal, Pearl, Tanzanite, Malachite, Turquoise, Lapis, and Coral.

OPERATION

1. Fill the stainless steel tank with a cleaning solution; Plug the power cord into a
grounded outlet; After power-on, the temperature displays the actual
environmental temperature, LED displays 3 minutes (default ultrasonic time).
2. Time setting: Press the "TIME-/TIME+ "quickly will increase/decrease time
1 minute a time, press and hold means time will increase/decrease 10 minutes at a
time. The cleaning stops when the timer counts down to 00:00. If
the cycle needs to be interrupted press "Ultrasonic" button.
NOTE: Do not run the cleaner continuously for more than one hour
3. Temperature setting: Press "temperature-/temperature+"quickly will
increase/decrease the temperature setting 1℃ at a time, press and hold will
increase/decrease the setting by 10℃ . Usually, the best cleaning temperature is
within 40℃ to 60℃.
4. Press "Heat" or "Ultrasonic" button to start either or both functions. Press "Heat"
button again, the heating function will stop. The same for Ultrasonic function.
5. Degas mode: works intermittently，i.e., 6s "ON" + 2s "OFF" working mode.
It can also be used to clean items effectively.
6. Drain: press the "drain" button to open or close the automatic valve. The
automatic valve will close after the default time (10 minutes)
7. Empty the tank and clean both the outside and inside of the cleaner with a clean and
dry cloth for next use.
5