Table of Contents
Advertisement
Quick Links
Download this manual
See also:
Instruction Manual
Advertisement
Table of Contents
Related Manuals for Sony SU-PW3M
Summary of Contents for Sony SU-PW3M
- Page 1 2-179-718-E1 (1) For Customers and Sony Dealers Wall-Mount Bracket SU-PW3M © 2004 Sony Corporation...
- Page 2 Sony is not liable for any damages or injury caused dropping can result. by mishandling or improper installation.
- Page 3 Do not remove screws, etc., after Do not expose the TV to rain or mounting the TV. moisture. If you do so, the TV may fall and cause injury or It may cause a fire or an electric shock. property damage. Never place the TV in hot, humid or Do not disassemble or make excessively dusty places, or in the...
- Page 4 CAUTION Precautions If the following precautions are not observed, injury or property damage may occur. • If you use the TV installed on the Wall-Mount Bracket for a long time, the wall behind or above the TV may become discolored or the wallpaper may Do not install the Wall-Mount come unstuck, depending on the material of the Bracket on wall surfaces where the...
-
Page 5: Installing The Wall-Mount Bracket
Be sure to tighten the screws To Sony Dealers securely in the designated position. The following instructions are for Sony Dealers If you fail to do so, the TV may fall, and cause bodily only. Be sure to read safety precautions described injury to someone or damage to the TV. - Page 6 Step 1: Step 2: Checking the parts Deciding on the required for the installation location installation Place the paper template on a perpendicular, flat wall and Prepare a Phillips screwdriver decide on the installation and the appropriate screws (four location. or more M8 (or equivalent) Tape the supplied 3 sheets of the paper template screws, not supplied),...
- Page 7 Step 3: Referring to the paper template and page 15, determine the Installing the Plate Unit positions of the screws. on the wall If you intend to route the cables in the wall, also determine the position of the cable hole and bore a hole in the wall.
-
Page 8: Step 4: Preparing For The Installation Of The Tv
Step 4: Adjust the angle of the stabiliser arms. Preparing for the When installing the TV perpendicularly (0 installation of the TV degrees), adjustment of the arms angle (step 1 and 2 below) is not necessary. Make sure that each stabiliser arm is screwed in securely. 1 Remove the screws that are at the top and Spread a soft cloth on the floor bottom center of the both stabiliser arms. -
Page 9: Step 5: Installing The Tv
Step 5: Attach the supplied four hooks with the four supplied screws Installing the TV (+PSW5 × L14). WARNING Be sure to complete the installation before connecting the mains lead to the wall socket. If you allow the mains lead to be pinched under or between pieces of equipment, this may result in a short circuit or an electric shock. - Page 10 Hitch the Mounting Rack on the Connect the mains lead and the hooks on the rear side of the TV. connecting cable(s) supplied Then slide the Mounting Rack with the TV to the TV. and fix it using the supplied Connect the mains lead and the connecting screws (+PSW5 ×...
-
Page 11: Confirming The Completion Of The Installation
Right side Install the Mounting Rack (with the TV) onto the Plate Unit. 1 Hold the Mounting Rack so that the two centre notches on either side touch the support braces of the Plate Unit. 2 Gradually lift the Mounting Rack and TV upward keeping the centre notches engaged with the support braces of the Plate Unit. -
Page 12: Checking The Operation Of The Woofer Speaker
Checking the operation When removing the TV of the woofer speaker To Sony Dealers This Wall-Mount Bracket is equipped with a Unplug the mains lead from the woofer speaker. After installing the Mounting Rack (with the TV) onto the Plate Unit, turn on wall socket. -
Page 13: When Connecting The External Equipment To The Tv After Installation
TV. external equipment to the TV after installation Restore the TV to the non-tilted To Customers, Sony Dealers position. 1 Unfasten the screws tightened at the outer sides of the bottom left and right hooks of the Mounting Rack in step 5 of procedure 1. -
Page 14: Specifications
Specifications Unit: mm Weight: 15.0 kg Design and specifications are subject to change without notice. PLATE UNIT ø 90 MOUNTING RACK 85.5 * When changing the position of the woofer speaker for installing a 50-inch TV: 590 SPEAKER 10 cm (2) Speaker unit 4 Ω... - Page 15 TV installing dimensions table TV Dimensions Unit: mm Length for each mounting angle Unit: mm Weight TV Model Mounting Weight (× 4)* angle (αº) 0º 5º KDE-W50A10 1336 10º 54kg 216kg 15º 20º * The wall that the TV will be installed on should be capable of supporting a weight of at least four times that of the TV. CAUTION This Wall-Mount Bracket is designed for use with the specified product above.
- Page 16 Printed in Japan...