Advertisement
Functions
OPERATION INSTRUCTIONS
Before operation: Place the unit in the area to
be used in for half an hour before turning it
on. It is recommended to use the unit under
temperature of 20˚C, relative humidity less
than 80% RH.
1. Locate a flat stable location and
plug the power cord into the
appropriate electrical outlet.
2. Remove the water tank from the base
by lifting and pulling upwards then
turn water tank upside down.
3. Unscrew the water tank cover and fill
water tank with clean water. Important:
Use only clean, cool tap water to fill the
water tank. Do not use hot water. Filtered
or distilled water is recommended to avoid
scale build up if tap water is too hard.
PRODUCT SPECIFICATIONS
MODEL CODE
POWER SUPPLY
POWER CONSUMPTION
WATER TANK CAPACITY
EVAPORATION RATE
NOISE LEVEL
4. Replace the water tank cover and position
the
water tank back onto the base.
5. Switch on the unit by pressing the power
button
. The unit will begin to work on
default setting (Mist level 1-normal).
6. To select MIST LEVEL: Press the power
button again to
change the mist level from level 1 (normal)
to level 2 (high).
Press power button again
to turn off the unit.
7. When water level in the water tank is low,
the unit will sound an alarm for 3 seconds
and then automatically stop operation.
The power button
red. Follow steps 2-5 to continue.
ULTRASONIC HUMIDIFICATION SYSTEM
CLI-AH100
100-240V 50/60Hz
20W
1.3 Litres
150ml/h
10 Hours
will illuminate
7
Advertisement
