Advertisement
Using the selector switch located on the right side of the control box select the desired mode
in which you wish to operate the light i.e. local or DMX.
Upon Power Up, the factory default setting will turn the light immediately to its full
brightness, unless any other specific "Power On" setting has been previously programmed
into the light.
AC Power
Sunfire Lights operate on standard single-phase AC power.
Input Voltage Range: 100 – 240Vac
Input Frequency Range: 50/60 Hz
NOTE: Standard Power Cord supplied with Sunfire Light is intended to connect with standard,
single-phase 110-120Vac, 60 Hz USA circuit. An adaptor for use with 240Vac, 50Hz European
circuit is also included. Other power cords for connection to other countries' single-phase circuits
are available as options. No other special adjustments or changes are required for operation at
international voltages.
WARNING: Never connect Sunfire Lights to anything other than a single-phase circuit.
Connection to three-phase power can/will cause serious damage and/or bodily injury.
Functional Requirements
The following section provides all the functional requirements for Lights Rotating Selector
Value – 00 – manual dimming using potentiometer on the front panel.
DMX Mode
This mode shall be active when the Address switch is set to DMX.
DMX Controller Interface Requirements
The software shall accept input from the DMX512 controller that represents user requested
values for Brightness.
The DMX input to the light is mapped as follows:
Channel 1:
Brightness: 0 – 255
One light need 1 DMX channel.
7
Advertisement
