GE Profile 26 Owner's Manual And Installation Instructions page 30

INSTALLING THE REFRIGERATOR
REMOVE THE FREEZER DOOR
7
Use the tip of a screwdriver to separate the rail from
E
the rail cover. Tilt the front end up and lift the entire door.
Set the door front on a nonscratching surface.
F
G Push the rail assemblies back into the cabinet.
CAUTION:
assemblies back at the same time.
REPLACING THE FREEZER DOOR
8
Two people may be required to complete this procedure.
ATTACH AND SECURE THE DRAWER FRONT TO
THE SLIDES
Pull out the rail assemblies to the full length on each side
A
of the cabinet.
CAUTION:
rails evenly.
Installation Instructions
(cont.)
Push both sides of the rail
Make sure to pull out the side
(cont.)
REPLACING THE FREEZER DOOR
8
Hang the freezer door front onto open slots
B
on the sides.
Tighten screws completely. (There are four
C
10 mm hex-head bolts.)
REPLACE THE FREEZER BASKET
Replace the freezer basket by lowering it into the frame.
30
(cont.)
Slot