Securing Child In Child Restraint - Safety 1st MultiFit Manual

11. Pull Bottom of Headrest
Pad Off of Headrest
Thread harness straps through slots in
headrest pad.
Thread harness straps through lower
shoulder harness slots in headrest and
through the slots in seat back (shell).
12. From the Back, Pull
Harness Straps Through
Shell
Harness straps
harness slots BELOW the metal bar as
shown. DO NOT twist harness straps.
13. Attach 2nd Harness Strap
Loops to Splitter Plate As
Shown
Sewn ends of the harness strap loops
MUST
DO NOT twist harness straps or harness
adjustment strap.
Make sure the same harness strap loops
are fitted COMPLETELY ON both sides
of the splitter plate.
Replace headrest pad around bottom
sewn
of headrest.
end
Correct
WARNINGS:
Harness system must be installed correctly.
The harness strap must be returned to the upper shoulder
harness slots as your child grows.
Failure to follow these steps can result in serious injury or
death.
11
MUST be in shoulder
face towards you.

Securing Child in Child Restraint

1. Place Child in Child
Restraint
The child's bottom and back should
be flat against the child restraint.
Position harness strap over child's
shoulders and upper thighs.
2. Buckle Harness
Push buckle tongues into buckle
until you hear them "click."
Pull up on harness strap to make
sure buckle is locked.
3. Close Chest Clip
Insert right half of chest clip into
left half and snap together.
4. Tighten Harness
Pull on harness adjustment strap
to tighten harness snugly.
5. Position Chest Clip
The chest clip must be placed at
mid-chest (even with armpits) and
away from the child's neck.
continued on next page
12