Advertisement
Quick Links
Q200/HE Hook-Up Guide
for Holter
Patient Preparation
• Select area over bone, avoiding muscle areas and breast tissue.
• C lean electrode sites aggressively with alcohol and use a razor
to remove hair.
• Abrade electrode sites with a scrub pad or gauze. Allow sites
to dry before applying electrodes.
• Firmly snap electrodes to the lead wires.
• Apply electrodes to appropriate sites. Press
adhesive border firmly for consistent adhesion.
• To help alleviate tension, loop and tape lead
wires down.
5-Electrode Placement
Tape
Electrodes
– +
RED BROWN
RED BLACK
WHITE BLACK
GREEN (Ground)
QRS Diagnostic
6901 E. Fish Lake Road, Suite 188
Maple Grove, MN, USA 55369
800.465.8408 | +1.763.559.8492 | Fax +1.763.559.2961
info@QRSdiagnostic.com | www.QRSdiagnostic.com
Ch. 1
CMS
Ch. 2
aVF
Ch. 3
lead II
Release Date: 04/12
Advena Ltd
33 Bridge St.
Hereford HR4 9DQ
UK
600005-00A
Electrode
0086
© QRS
Advertisement
Related Manuals for QRS Q200/HE
Summary of Contents for QRS Q200/HE
-
Page 1: Patient Preparation
Q200/HE Hook-Up Guide for Holter Patient Preparation • Select area over bone, avoiding muscle areas and breast tissue. • C lean electrode sites aggressively with alcohol and use a razor to remove hair. • Abrade electrode sites with a scrub pad or gauze. Allow sites to dry before applying electrodes. • Firmly snap electrodes to the lead wires. • Apply electrodes to appropriate sites. Press Tape Electrode adhesive border firmly for consistent adhesion. • To help alleviate tension, loop and tape lead wires down. 5-Electrode Placement Electrodes – + Ch. 1 RED BROWN Ch. 2 RED BLACK Ch. 3 lead II WHITE BLACK... -
Page 2: General Settings
Q200/HE Quick-Start Guide for Holter To start recorder for Holter Step 1 I nsert formatted SD Card (using Q200 format) and battery into recorder. Step 2 S creen will display “Q200/HE” and “QRS Diagnostic” information.* Press ENTER to continue to main menu. Erase memory if prompted to do so. Step 3 I f desired, adjust Settings by using arrows – , and – to move the cursor and the ENTER button to select. Use arrows to navigate to General Settings menu and to adjust entries. Press ENTER to select and return to menu. Step 4 F rom main menu go to New Patient screen to verify or enter Patient ID. At least one character must be entered for Patient ID. Step 5 U se arrows and ENTER to input ID and press EVENT when finished. (Hold down ENTER button to backspace.) Recorder will now start automatically after 10 minutes or by pressing EVENT button for 3 seconds. ECG signal and quality will appear on screen.