Table of Contents
Advertisement
SECTION II
INSTALLATIOK
1)
Turn System power off.
CAUTION! NEVER INSTALL OR REMOVE A CIRCUIT CARD
WITH POWER ON!
2)
Install card in any card slot. If the FDC-3 card replaces an FDC-
2 card, install in
same slot to avoid having to move cables.
Note that the edge-connector location prevents plugging the card
in backwards.
3)
Plug signal cable(s) into FDC-3 card.
Cable from standard (8")
drive(s)
plugs
into large connector.
Cable from
miniature
(5.25")
drive(s)
plugs
into
small
connector.
Be
sure
connector (s)
firmly seated.
4)
Turn System on, with all drive doors open.
If T/DOS Version 1.44
(or lower) information appears (after CRT warmup) with drive
doors open, FDC-3 card will not work properly.
5)
Place System diskette(l) in drive A(2), close drive door, wait
for
memory-size prompt,
then enter size (in K)
for desired
program, or press RETURN to load maximum size automatically.
6)
Check CRT Display. If T/DOS Version 2.0 (or higher) installed,
System is ready for operation.
(1) Consult local documentation, Supervisor, or Dealer for correct
diskette insertion method on your System.
Diskette should not be
Wr i te-Protected,
if recording on disk et te requi red.
(2)TEI, Inc. Systems with eight function keys on keyboard, can load
T/DOS Version 2.0 (or higher) from drives B,
C,
or D,
if desired.
Press key 8 to load from drive B, key 7 to load from drive C, keys 7
and 8 to load from drive D.
2-1
Advertisement
Table of Contents
