Summary of Contents for Oasis 330R
- Page 1 Assembly and Operating Manual Oasis Rolling Base 330R Oasis Rolling Base 330R with Quick Clamp Accessory QC-2...
- Page 2 Model Permissible pole diameters Illustrations in this manual show the sunshade stand Oasis Rolling Base 130R as an ex- ample. They are intended for general understanding and can differ from the actual model. 330R 45 to 68 mm (1.77 in to 2.68 in)
-
Page 3: Table Of Contents
Care Disposal Table of contens In case of problems Introduction 7 Care For your safety Intended use Scratching of the casing and mounting tube due to incorrect care! Symbols in the manual Do not use aggressive or abrasive cleaners (such as steel wool), which can dama- ge the surface of the sunshade stand. -
Page 4: Introduction
1 Introduction 6 Disassembly at end of season With your choice of the Oasis sunshade stand you have purchased a high-quality product At the end of the season the sunshade stand should be stored as follows: featuring a patented and unique design that allows you to move the sunshade while in use to any spot on your terrace, while maintaining an upright posture. -
Page 5: Symbols In The Manual
Using the sunshade stand Symboles in the manual Safety notices Inserting the sunshade 5.2 Moving the sunshade stand 2. Open the quick-release clamp by pulling the clamping lever away from the moun- ting tube (Fig. 21). 2.2 Symbols in the manual 3. - Page 6 Modell: 330R with quick clamp accessory QC2 For model 330R with quick clamp accessory QC2, insert the sunshade as follows: 1. Make sure that the sunshade stand is in standing position, i.e. the telescoping rod...
- Page 7 • Do not leave the sunshade stand unattended when the sunshade is open. Fastening the mounting tube and the clamp on 330R with quick clamp accesso- ry QC2 models Tilted sunshades can unexpectedly turn as a result of the wind, resulting in property dama- 1.
-
Page 8: Scope Of Delivery
330R with quick clamp accessory QC2 Assembly The sunshade stand must be assembled as follows: Mounting tube Quick-release clamp Reducing sleeves Place the blanket, etc. -
Page 9: Unpacking The Sunshade Stand
Assembly of the sunshade stand Scope of delivery Figures to the assembly instructions Unpacking the sunshade stand The sunshade stand is delivered in five parts (Fig 1): Figure 17 Figure18 Figure 19 1 sunshade stand 4 weight segments Before unpacking, check all packing units for obvious damage from trans- port. - Page 10 330R top site bottom site Figure 12 Figure 13 Figure 13.1 Figure 4 Figure 5 Figure 6 330R QC2 version 330R QC2 version 330R QC2 version Figure 14 Figure 15 Figure 16 Figure 7 Figure 8 Figure 8.1 330R QC2 version...