Harman Kardon Enchant Series Instructions

Demo Mode and Hotel Mode Instructions for
Harman Kardon Enchant Soundbars
Description
1. Remote control function is disabled
2. Bluetooth and Wi-Fi are disabled
3. The soundbar will not enter standby mode
4. Demo mode will remain active, even after power cycle
5. The soundbar features a general version of the MultiBeam surround effect that can work for
most rooms.
6. The soundbar will features a default volume level that resets after 90 seconds of inactivity.
7. Only VOLUME UP, VOLUME DOWN, and SUBWOOFER PAIRING buttons are enabled on the
soundbar.
8. The soundbar will automatically detect ONE active demo source input: OPTICAL, AUX,
or HDMI ARC connectors. Once the soundbar has detected the demo source input, the
soundbar will remain on this input and will not change.
9. If a subwoofer is paired, a user can mute the subwoofer by pressing the VOLUME UP and
DOWN buttons at the same time.
To Enable Demo Mode
1. Remove the power cable from the soundbar.
2. Connect ONE audio source to the soundbar back-panel connectors: Optical, Aux, or HDMI
ARC.
3. Plug in the power cable while pressing and holding VOL UP & SOURCE buttons on the
soundbar top-panel.
4. The front display will display "DEMO" to indicate that the bar is in demo mode.
5. The soundbar will enter subwoofer-pairing mode. If connecting to a subwoofer, press the
PAIRING button on the subwoofer to connect
To Disable Demo Mode
Repeat the Steps to Enable Demo Mode
DEMO MODE