Page 1
Mackworth Stand Aid SA160E User Manual Unit 1, Tir Llwyd Industrial Estate, St Asaph Avenue, Kinmel Bay, Rhyl, Conwy, LL18 5JA Tel +44 (0)1924 840100 www.prismmedical.co.uk info@prismmedical.co.uk SA160E User Manual Rev 3 - Aug 2016 Page...
Table of Contents Mackworth SA160E - Stand Aid 1.0 Assembly instructions Page 1.1 Initial Assembly 2.0 Stand Aid Features 2.1 Emergency Stop Button 2.2 Emergency Lowering 2.3 Control Box 2.4 Handset 3.0 Operating instructions 3.1 To Alter the Leg Width 3.2 Positioning...
1.0 ASSEMBLY INSTRUCTIONS Mackworth SA160E Stand Aid 1.1 Initial Assembly Remove carefully from the box: Boom / Mast assembly Base unit with legs attached (Base Unit) Battery pack / charging lead Hand set control Foot Plate Document wallet Battery Pack...
Page 4
1.0 ASSEMBLY INSTRUCTIONS Mackworth SA160E Stand Aid Carefully take the boom/mast assembly and slide bottom of the mast into the base socket. When the mast is fully engaged into the base, fit both of the 2 mast locking knobs and tighten by...
Page 5
You have a choice where the mains cable can be stored, either away from the hoist or it can be stored at the side of the battery pack / control unit. See page 11. SA160E User Manual Rev 3 - Aug 2016 Page 5...
To re-set the button after it has been pressed, simply twist slightly clockwise and the button will spring outwards. NOTE: THE STAND AID WILL NOT OPERATE WITH THE STOP BUTTON PUSHED IN SA160E User Manual Rev 3 - Aug 2016 Page 6...
The ring is situated at the top of the actuator where the actuator connects to the mast. Twist Clockwise to Lower Electrical emergency lowering: is facilitated by pressing the button on the control box. Electrical Emergency Lowering Button SA160E User Manual Rev 3 - Aug 2016 Page 7...
The back of the handset has a hook that enables the user to position the handset anywhere on the boom whilst attending to the patient. Clear and easy to understand button diagrams enable ease of use for the caregiver. SA160E User Manual Rev 3 - Aug 2016 Page 8...
Stand Aid or sling, for their own and the clients safety and comfort. These instructions are designed to cover the method of using of the Mackworth Stand Aid 3.1 To Alter the Leg Width The legs on the base unit of the Stand Aid are operated by adjusting the leg lever pedal, as shown in the photo below.
To a lower person, press and hold handset button marked with downward facing arrow and Stand Aid will descend. When you have reached desired level, simply release button and Stand Aid will stop in that position. SA160E User Manual Rev 3 - Aug 2016 Page 10...
The charger lead can either be wrapped around the side of the control box, as shown, or stored separately NOT expose the battery or control box to water SA160E User Manual Rev 3 - Aug 2016 Page 11...
4.0 SAFETY PRECAUTIONS Please read and follow the safety precautions listed below. The operation and the use of the SA160E Stand Aid is straightforward. These basic safety precautions will help make lifting operations easy and trouble free. ALWAYS conduct a risk assessment to plan your lifting operations before commencing.
Page 13
NEVER dispose of the battery pack in a fire as this may cause an explosion. These need to be disposed under the W.E.E.E. regulations. The SA160E’s brakes may be left on or off following a risk assessment of the client and the environment YOUR Stand Aid is for patient lifting.
5.2 Warning Notes Your Mackworth SA160E Stand Aid has been manufactured and tested to exceed BS EN 10535:2006 This does not mean that it can be used without care. ALL OPERATORS should have read the operating instructions and appreciate this warning section.
Assembled SA 160 46 Kgs Mast & Boom ( Including all fittings ) 23 Kgs Base Assembly 23 Kgs Battery 3 Kgs 6.2 Sound Levels— Measured in dB A SA160E Unloaded Loaded SA160E User Manual Rev 3 - Aug 2016 Page 15...
Internal Power Source Degree of Shock protection - Hoist Type B The policy of Prism Medical UK is one of continual improvement and we reserve the right to modify designs without notice. SA160E User Manual Rev 3 - Aug 2016 Page 16...
6.5 SA 160E Main Assembly Components Boom Battery Box Attachment hooks Handset Control Unit Knee Pad Leg Lever Pedal Foot Plate Lockable Rear castors SA160E User Manual Rev 3 - Aug 2016 Page 17...
If the above checks prove unsuccessful, contact your nearest MACKWORTH APPROVED AGENT 7.2 Service / Maintenance Any work performed on the SA160E must be in accordance with the specifications detailed in the test requirements of BS 10535:2006. You should also consider if the hoist requires servicing in accordance with “LOLER REGULATIONS”...
LL18 5JA, UK Tel +44 (0) 844 980 2296 Fax +44 (0) 844 980 2297 Declares that the manufactured product:- Product Name: Mackworth - Stand Aid Model Number (S): SA160E Product Options: 160 Kg Conforms to the following European Union Council Directives:-...
4) This guarantee does not apply to failure attributable to normal wear and tear, damage by natural forces, user neglect or misuse or to deliberate destruction. Exemptions: Batteries will be guaranteed for a period of 90-days after original purchase. SA160E User Manual Rev 3 - Aug 2016 Page 20...
Be sure to have this piece of equipment serviced on a regular basis (6 monthly where LOLER applies). PURCHASE INFORMATION: Product Name: Mackworth Stand Aid Model: SA160E Date of Purchase: __________________ Serial#: ________________________ Purchased From: ____________________________________________________ Address: ___________________________________________________________...
The maximum load for the sling is clearly marked on the label of the sling. The maximum load will also be displayed on the hoist and any detachable elements of the hoisting system. DO NOT exceed the maximum load stated on any of the equipment. SA160E User Manual Rev 3 - Aug 2016 Page 25...
Page 26
Important - always peel the sling away from the person to avoid skin friction and movement. Note: The above & following techniques are for guidance only and you must comply with your local policies.. If in doubt, consult your moving and handling advisor SA160E User Manual Rev 3 - Aug 2016 Page 26...
Page 27
Using the Posterior Sling in conjunction with the Standing Support Sling The posterior straps must first be attached to the Mackworth SA160E by following the diagrams below: Thread loop of posterior strap under lower bar. Thread hook through the end of the loop and pull through to form attachment to lower bar.
Page 28
While every effort has been made to ensure the accuracy of information contained in this user manual, no liability can be accepted for any errors or omissions. Mackworth operates a policy of continuous improvement where specifications and other data are subject to change without notice.
Need help?
Do you have a question about the SA160E and is the answer not in the manual?
Questions and answers