Table of Contents
Advertisement
⚫
If mounting to stud-wall or similar surface you will need to use specialized expansion plugs for that
surface. These are not provided in this kit but are available at all good DIY stores.
⚫
Mounting to false ceilings, ceiling tiles etc. also requires additional materials not provided in this kit.
Typically, you would need to use a wooden backing board above the ceiling tile to bolster the
ceiling tile and provide a strong surface to support the screws. For this you would need longer
screws than those provided but of the same diameter.
Step 2
Install camera. Screw the fixing ring back onto the mounting bracket to reassemble the camera. Take
care not to twist or damage the cable. Don't tighten the fixing ring completely yet.
Step 3
Adjust the camera to the desired monitoring angle (take care not to damage the cable inside the
mounting ring housing as it can snag on the ball mount) and then tighten the fixing ring properly to lock
the camera rotation and tilt.
Step 4
Connect the camera video output port to the HDCVI DVR and connect the power port to power.
Physical camera installation is now complete! Now switch on the DVR to check monitoring image.
Power
Note that the power requirements for this camera are quite modest (12V x 0.26A = 3.2W), so you can
split the power from a 2A mains adapter to supply 4 cameras quite safely
3 Adjusting camera settings
Cross-refer with your DVR instructions as they will be specific to your DVR. Instructions below are
generic.
Now use the mouse connected to the DVR to navigate the onscreen menus on your TV or computer
interface.
6
Advertisement
Table of Contents
