Digi-Code 5030 Installation Instructions

Garage Door Opener Radio Controls
Model 5030 (300 mHz) \ 5032 (310 mHz) Three Button Transmitters
• • • • Disconnect operator power before any installation or repair
• • • • Always wear safety glasses
Your Digi-Code radio controls are designed specifically to remotely control a garage
door opener from within an automobile and to give years of trouble free service without
adjustment. Because all radio controls are set with the even numbered switches in the
"ON" position when they leave the factory, it is recommended that a different code
be selected and set at the time of installation. Please refer to the "Setting the Code
Switch" section for instructions. The radio frequency (RF) portion of the controls,
however, are tuned to standard frequencies and are thoroughly tested at the factory. This
permits the addition or replacement of either the transmitter or the receiver by specifying
the Model number and the RF frequency designated on the identification label. RF
adjustments are not needed nor should any be attempted.
SETTING THE CODE SWITCHES
On the transmitter the entire front lower half of the case ( " the battery hatch" ) is
removeable. Use a coin or the curved end of the visor clip to disengage the lower half of
the transmitter front. This will expose both the code switch and the battery compartment.
( SEE FIGURE #1 )
Installation Instructions
WARNING:
SECTION #1