Advertisement
SETTING THE SINGLE BUTTON CODE SWITCH
Set code switch positions 1 through 10 to your personal code scheme, any combination of
"on" or "off" positions can be selected (Note: The switch is in the "on" position when
it is depressed toward the number.). We strongly urge that several coding schemes be
avoided: ALL ON; 2,4,6,8,10, ON. These positions are similar to our or other
manufacturers test positions, or are frequently used.
SETTING RECEIVER – TO WORK WITH SINGLE BUTTON
Set the receiver code switches to match the code settings you entered for the single button
switch in the transmitter, being sure both are set the same since a different setting of just
one switch will prevent operation.
Once the three codes have been set, check operation and reinsert the hatch.
SETTING THE TRANSMITTER CODE SWITCHES –TO WORK WITH
EXISTING STANLEY GARAGE DOOR OPENERS.
Set the transmitter using "SETTING THE DUAL BUTTON CODE SWITCH" AND
"SETTING THE SINGLE BUTTON CODE SWITCH" instructions from section #1
above.
Set the first garage door opener using "SETTING RECEIVER #1 (WORKS WITH
LEFT DUAL BUTTON) " instructions from section #1 above.
Set the second garage door opener using "SETTING RECEIVER #2 (WORKS WITH
RIGHT DUAL BUTTON )" instructions from section #1 above.
Set the third garage door opener using "SETTING RECEIVER – TO WORK WITH
SINGLE BUTTON " instructions from section #1 above.
TRANSMITTER BATTERY REPLACEMENT
The battery in the transmitter can be checked or changed by removing the front lower
half of the transmitter. Use a coin or the curved end of the visor clip to disengage the
lower half of the transmitter front. This will expose the battery compartment.
Replacement battery must be a 9-volt.
SECTION #2
SECTION #3
Advertisement
