Advertisement
Figure #1
Once you have removed the battery hatch, locate the "CODE SWITCHES" above the
battery. As shown above, the dual buttons are controlled by the right hand switch and the
single button is controlled by the left hand switch.
Before setting the receiver code switches, you will need to set the transmitter code
switches on your model 5030 or 5032. We strongly suggest that you change the code
from the factory setting to provide security for your own system, and to eliminate
interference with neighboring systems.
SETTING THE DUAL BUTTON CODE SWITCH
Set code switch positions 1 through 9 to your personal code scheme ( THE 10
POSITION SWITCH MUST BE SET IN THE CLOSED POSITION "ON"), (Note:
The switch is in the "on" position when it is depressed toward the number.). We
strongly urge that several coding schemes be avoided: ALL ON; 2,4,6,8,10, ON. These
positions are similar to our or other manufacturers test positions, or are frequently used.
SETTING RECEIVER #1 (WORKS WITH LEFT DUAL BUTTON )
Set your receiver code switch positions 1 through 9 to match the dual button code switch.
Then make sure that the 10
position "ON". The left dual button on the transmitter should now operate this receiver.
SETTING RECEIVER #2 (WORKS WITH RIGHT DUAL BUTTON )
Set the receiver code switch positions 1 through 9 to match the dual button code switch.
Then make sure that the 10
position "OFF". The right button on the transmitter should now operate this receiver.
Once the codes have been set, check operation.
th
position switch on receiver #1 is set in the closed
th
position switch on receiver #1 is set in the open
TH
Advertisement
