The box comes with Velcro hook and loop tape to attach the suppressor to multiple surfaces.
Below are the components that will be needed for this install.
Directions
1. Wipe down and clean the surface intended for the suppressor. Pull off one side of the Velcro tape as to expose the adhe-
sive, and attach it, adhesive side down, to the surface.
2. Pull off remaining side of the Velcro tape as to expose the adhesive, and attach it, adhesive side down, to the bottom of
the suppressor (side with mounting bracket).
The facts and figures herein are carefully compiled to the best of our knowledge and are intended for general informational purposes only. Responsibility
for the use and application of AccelTex Solutions materials rests with the end user. All AccelTex Solutions products are sold pursuant to the AccelTex