Advertisement
■EU Declaration of Conformity
This device bearing the CE marking is in compliance with the essential requirements and other relevant provisions
of Directive 1999/5/EC. This device complies with the following harmonized European standards.
EMF: EN62479:2010
Safety: EN60950-1:2006+A11:2009+A1:2010+A12:2011
EMC : EN301 489-1 V1.9.2.1:2011, EN301 489-33 V1.1.1:2009, EN55022:2010 Class B, EN55024:2010
Radio: EN302 065 V1.2.1:2010
This product is carrying the CE-Mark in accordance with the related European Directives.Responsible for CE-
Marking is TOSHIBA EUROPE GMBH, Hammfelddamm 8, 41460 Neuss, Germany. The complete and official
EU Declaration of Conformity can be found on TOSHIBA's web site
http://epps.toshiba-teg.com on the Internet.
The product is not CE marked itself because of the total size but the product is fully compliant to the relevant
R&TTE requirements for C marking.
■CE compliance
This product is labeled with the CE Mark in accordance with the applicable
European Directives, notably RoHS Directive 2011/65/EU, Radio
Equipment and Telecommunications Terminal Directive 1999/5/EC and the related implementing measures.
This product and the original options are designed to observe the related EMC (Electromagnetic Compatibility)
and safety standards. However, TOSHIBA cannot guarantee that this product still observes these EMC
standards if options or cables not produced by TOSHIBA are connected or implemented. In this case the
persons who have connected/implemented those options/cables have to provide assurance that the system
(PC plus options/cables) still fulfils the required standards. To avoid general EMC problems, the following
guidance should be noted:
- Only CE marked options should be connected/implemented
- Only best shielded cables should be connected
■Working environment
This product was designed to fulfil the EMC (Electromagnetic Compatibility) requirements to be observed for
so-called "Residential, commercial and light industry environments". TOSHIBA do not approve the use of this
product in working environments other than the above mentioned "Residential, commercial and light industry
environments".
For example, the following environments are not approved:
- Industrial Environments (e.g. environments where a mains voltage of 380 V three-phase is used)
- Medical Environments
- Automotive Environments
- Aircraft Environments
Any consequences resulting from the use of this product in working environments that are not approved are
not the responsibility of TOSHIBA.
9
Advertisement
