Linking Two Solar Stones To Each Other For Stereo Sound - ION Solar Stone Quick Start Manual

Hide thumbs Also See for Solar Stone:

Linking two Solar Stones to each other for stereo sound:

Note: Ensure that the speakers are not already Bluetooth connected in single mode. If either

of them is connected, hold the Bluetooth Connect button to disconnect and then follow the

steps below.

Power on each Solar Stone by holding down their power buttons. You will hear "Power

On" for confirmation. *

Press the Link button on each Solar Stone. The speakers will search for each other while

playing an intermittent tone. Once the stereo pair is successfully linked, you will hear

"Pairing successful, connected" followed by "Left channel" and "Right channel" on the

respective speakers. *

This process may take up to 2 minutes the first time two speakers are linked, but will only

take a few seconds if the speakers were previously linked.

Note: Solar Stones should be within 30 ft. (9 m) of each other to Link properly.

On the Left speaker, the Bluetooth LED will blink. Press the Bluetooth Connect button

to enter Bluetooth Pairing mode.

Note: The Left speaker will be the "master" speaker, and the unit from which the

Bluetooth range will be determined.

Navigate to your device's Bluetooth setup screen, find Solar Stone, and connect. You

will hear "Connected" for confirmation. *

Note: If you experience trouble in connecting, select "Forget this Device" for Solar Stone

on your Bluetooth device and try to connect again.

To disconnect linking, hold the Link button on the "master" Solar Stone for 5 seconds.

You will hear "Disconnected" for confirmation. *

If your Bluetooth device is not able to connect to Solar Stone, hold the Bluetooth

Connect button on the speaker to break previous Bluetooth connections and reset the

Bluetooth module.

Note: When two speakers are linked, hold the power button on the "master" speaker to

turn both speakers off. If you want to only turn off the "slave" speaker, press and hold the

power button on that speaker. The speakers will relink automatically the next time they

are both powered on.

* Tip: If you would like to disable (or enable) the voice prompts, simultaneously press the

Bluetooth Connect and Link buttons.