Weight Based Grinding Operation; Programming; Burst Mode - Baratza Sette 270Wi Manual

®

WEIGHT BASED GRINDING OPERATION

Place the portafilter or grounds bin onto the convertible arms. Press a preset button (1,2,3). The screen will show the
corresponding programmed grind weight in grams. Press ''START''. There may be a slight delay as the machine tares and
then begins grinding. While grinding, the screen will count up in grams to the target weight, the motor will stop, hitting the
desired gram amount.
If you would like to stop before the cycle has completed, press the STOP button.
This will turn the motor off, and reset the screen to your initially chosen grind weight.
However, if you would like to pause the grind without resetting to the initially chosen
grind weight, press the PAUSE button. This will immediately pause the machine.
Pressing ''START'' will resume grinding until the unit reaches the desired weight. To
reset the grind cycle press the STOP button.

PROGRAMMING

The Sette 270Wi is equipped with three programmable buttons (1, 2, 3). These only adjust the desired grind weight, they do
not adjust the grind setting (i.e. coarse/fine). Each button comes from the factory with the following presets: 1=18g, 2=25g,
3=35g.
You can easily adjust the presets by following these steps:
1. Select a preset button.
2. Press the up or down arrow buttons to adjust the weight.
3. Once you have reached the desired weight setting, press and hold the preset button for three seconds, at
which point the screen will blink to confirm. The setting is now saved, even if the grinder is unplugged.

BURST MODE

If during weight based grinding operation, a preset grind cycle is stopped within five grams of the target weight due to
interference, pressing ''START'' will provide a very short burst of grinding that can be repeated indefinitely. Use this mode to
"top off" a dose. Exiting this mode requires removal of the grounds bin/portafilter or pressing the STOP button.
If the grinder stops more than five grams before the target weight, the grinder will not enter Burst Mode and instead will
behave as if paused. Simply press ''START'' once more to resume grinding towards the target weight.
Note that the Sette 270Wi, when new, will require 3 to 4 grind cycles to acquire an accurate
offset and dose within a few tenths of a gram of the target.
SETTE 270W i MANUAL
Coarse Fine
31 29 27 25 23 21 19 17 15 13 11 9 7 5 1 3
Finer Coarser
A B C D E F G H I
v2.1 May 11, 2018
7