Advertisement
GAMMA instabus
Technical Product Information
February 2010
Blind actuator UP 520/31
Outputs:
A blind actuator is switching an electrical drive, which is
configured for two rotating directions (Up/Down). (cf.
figure 5)
Prog.
BK
L1
L2
L3
N
Figure 5
Note
• The outputs of the blind actuator are electrical
interlocked
V
Danger
• The soldered end of lines have to connect by using
the attached clamps.
• Do not connect three-phase AC motors to blind
actuators
• Observe the instructions of the motor
manufacturers if motors are to be connected in
parallel. Otherwise risk of irreparable damage to
the motors.
• Use only blinds or shutters with limit switches
(mechanical or electronic). The limit switches of
the connected motors must be checked for correct
adjustment.
Technical Manual
Update: http://www.siemens.com/gamma
2.10.1.18/4
EIB+ / RD
EIB- / BK
A
/ GN
com / WH
B
/ YE
com / BN
~
U
230V
n
µ
µ
L
BN
PK
M
Subject to change without further notice
Dimensioned picture
Dimensions in mm
Ø = 53 mm
Height = 28 mm
General notes
•
Any faulty device is to be returned to the local Siemens
office.
•
If you have further questions concerning the product,
please contact our Technical Support:
℡ +49 (0) 180 50 50-222 (0,14 €/min. from the German
landline network, deviating mobile communications
prices are possible)
+49 (0) 180 50 50-223
E-Mail: support.automation@siemens.com
Internet:
www.siemens.com/automation/service&support
UP 520/31, 4 pages
© Siemens AG 2010
5WG1 520-2AB31
Figure 6
Siemens AG
Industry Sector, Building Technologies
Low Voltage Distribution
PO Box 10 09 53, D-93009 Regensburg
Advertisement
