Set Time; Set Default - Jamar Traffic Counter Tester II User Manual

Traffic Counter Tester II User's Manual

Set Time

The Set Time mode is used to
set the length of time that a test
will run. This setting is shown
on the fourth line of the display
to the left. To set the time, press
the TAB key until Set Time is
shown at the top left of the display. Then press the DO key to cycle
through the options of 15 min., 30 min., 45 min., 1 hr., 2 hr., 5 hr., 24
hr., and "—-". When a test is started, it will run for the length of time
specified and then stop. The option "—-" is used to specify continuous
operation.

Set Default

The Set Default mode is used
to restore the setting in the
TCTII to the factory defaults.
To restore the defaults, press
the TAB key until Set Default
is shown at the top left of the
display. Then press the DO key and you will be asked if you want to
reset the TCTII to factory defaults. Select Continue to reset the TCTII
or Cancel to return to the main menu without resetting to the defaults.
SET TIME
CLS: 2
TUBE: 2 ft
T:----
SET DEFAULT
CLS: 2
TUBE: 2 ft
T:----
2-6
#V:00000
SPEED:35
STOPPED
#V:00000
SPEED:35
STOPPED