Setting Up The Traffic Counter Tester Ii - Jamar Traffic Counter Tester II User Manual

Setting Up the Traffic Counter Tester II

First, attach the air tubes to the nozzles on the TCTII, making sure that
each tube is the same length. At this point, it may be useful to mark the
tube for channel A with a piece of electrical tape to aid in identifying the
two channels. Next, plug the TCTII power supply into an electrical outlet
(110V@60Hz) and connect it to the TCTII.
Caution: Only use the power supply provided with the TCTII. Substitutes
may damage the unit. Be sure to connect to the TCTII before plugging into
the outlet.
Once the power supply has been connected, turn on the TCTII by sliding
the power switch to the ON position. At this point, the unit should be on,
and the display should show the following:
Connect the air tubes to the air switch inputs on traffic counter that you
are going to test. If you are testing a four tube counter, the pair of splitters
supplied with the tester should be connected to the end of the air tubes.
The Output dial, which is used to adjust the strength of the air pulse gener-
ated, should be set to 10. Refer to chapter 3 for more information on the
Output dial.
Chapter 2 — Operation of the Traffic Counter Tester II
A,B
CLS: 2
TUBE: 2 ft
T:----
#V:00000
SPEED:35
STOPPED
2-3