Step 4 Remote Dc Operation; Step 4 - Belkin PureAV Power Console PF60 User Manual

Hookup and Installation

Step 4

Remote DC Operation
This function allows you to turn your Power Console on and off via any
component that is equipped with a 3~30V DC output (low-voltage trigger out).
Note: You cannot turn off the switched outlets on the Power Console
with the switched button on the front of the unit when there
is any external power signal supplied to either the AC or DC
remote inputs.
To install the Remote DC Control Cable:
A. Connect the Remote DC Control Cable (included) into the outlet labeled
"DC IN" on the rear panel of the Power Console. (Fig. 4a)
B. Press the "Remote" button on the front of the Power Console to turn
on the remote function. The LCD display should read "REMOTE ON".
(Fig. 4b)
C. Press the "Switched" button on the front of the Power Console to turn
off the switched outlets.
D. Connect the other end of the Remote DC Control Cable into the 3~30V
output (low-voltage trigger out) on your component. When you turn on
the component, the outlets on the Power Console that are programmed
as "Switched" will be turned on immediately and the Switched/Delayed"
outlets will come on after a delay set by the "Delay Time Switch".
11
Figure 4a Figure 4b