Advertisement
Wear the headphones.
Before listening
Start playback of the A/V component.
To reduce the risk of hearing damage, first lower the volume .
00
+
Tactile dot
Adjust the volume.
Up
◄
•
Down
( (
(4)
) )
VOL.._
Tactile dot
•
~
OFF
ON
,,.,,
-•-
,,,,,
.
.
.
. .
~~---~
,,111,
---
'''"'
POWER/CHARGE
(Green)
After use
Turn off the power of the headphones.
About sending RF signals
The transmitter starts sending RF signals
automatically when it detects an audio signal from
the connected component. Note that;
- Noise may occur depending on the transmitter
position and room conditions. It is recommended
to place the transmitter in a location that
produces the clearest sound.
-
If the transmitter is placed on a metallic table,
you may hear noise, or the reception range may
decrease. Do not place on a metallic table.
If no signal or low signal is
input for about 4 minutes
When no signal is input for about 4 minutes, the
transmitter turns off automatically*. The POWER
indicator of the transmitter blinks for 4 minites,
then turns off. The transmitter restarts after
receiving an audio signal again.
The transmitter may also turn off if low signal is
input for about 4 minutes. In this case, raise the
volume of the connected AN component within
the range where the sound is not distorted, then
lower the volume of the headphones.
* If signal noise is output from the connected AN
component, the transmitter may not turn off,
even when no audio signal is input.
Advertisement
