Evenheat RampMaster II Programming Reference

Cone Fire Mode

This method is used to fire ceramics, porcelain, & pottery to a specific cone number
using different firing times. Total firing times may vary depending on cone number selected.
13 hours to reach 04 Cone
10 hours to reach 04 Cone
Example: Simple 7 hour firing:
1. Turn Power Switch On (Proceed once
2. Press the
3. Press the number keys for the Cone you wish to fire, then the
♦ Such as
4. Press the number keys for the amount of Hold time desired, then the
♦ Such as
5. Press the number keys for the rate of cool down desired, then the
(If none, then enter "0" and it will skip this option and go to IDLE)
♦ Such as
6. Press the number keys for the temperature you wish to control the cool down to, then
the Button.
♦ Such as
7. Press the number keys for the amount of hold time you wish to hold the end
temperature, then the
♦ Such as
8. Press the
♦ The display will read
9. Press the
For more complex firings using additional features, refer to your complete operating manual.
RampMaster II
Easy Reference Programming
Button, then the
for an 04 Cone
. for 15 minutes
for 150 degrees an hour
for 1500 degrees
Button.
. for no hold time.
Button
"-- -- -- --".
Button to initiate the firing.
7 hours to reach 04 Cone
4 hours to reach 04 Cone
WAIT is no longer in the display)
Button.
Button.
Button.
Button.