Advertisement
Welcome and thank you for choosing MarkAudio Sota.
Markaudio-Sota's engineering approach using full range audio driver technology with
minimal control networks and laminate cabinet construction are the keys that can unlock the
enjoyment of audio in the home. This is a high performance product that rewards careful
amplifier, source and cables selection along with thoughtful room positioning.
Please take the time to read this manual before you begin.
1. Unpacking
Carton contents: Please check in the 2 cartons for
Supporting
Speaker unit
Speaker grill
rubber foot
x 2
x 2
x 8
2. Environmental Information:
This product complies with international directives, including but not limited to:
i.
The Restriction of Hazardous Substances (RoHS) in electrical and electronic equipment,
ii.
The Registration, Evaluation, Authorisation and restriction of CHemicals (REACH)
iii.
The disposal of Waste Electrical and Electronic Equipment (WEEE).
Please consult your local waste disposal authority for guidance on how properly to recycle or dispose of this
product.
All bags should be kept away from babies and small children.
3. Speaker Installation:
Step 1
Install the speaker
grill to cabinet front
surface.
Magnet on speaker
grill and cabinet will
align the position.
Warranty card
Foam plug
User manual
x 1
x 2
x 1
Step 2
The speaker is designed
to be mounted on 4
supporting rubber feet
(supplied), but may be
placed on a Cesti T
stand (FS-CT) available
separately if preferred to
optimize the
performance.
4. Speaker positioning
Room acoustic performance varies. Adjusting the speaker positions may further improve the sound quality.
Typical placement of loudspeakers is either side of a TV. Start by placing the loudspeakers approximately 2.5
metres to 3 metres apart with a minimum clearance from a back wall of 100mm with the foam bung fitted into the
rear port. Enhanced bass output can be done by moving the foam bung from the rear port and fitting into the
front port. Experiment by angling the loudspeakers toward or away from your central listening position to suit your
tastes.
back
Front
Foam plug
positioning
Big Listening room
5. Connections
All connections should be made with the audio equipment switched off.
Ensure terminals to each loudspeaker are correctly connected. Follow our wiring cable diagram. Connect the
positive feed from the amplifier to the red loudspeaker terminal. The negative amplifier feed connects to the
black terminal on the loudspeaker.
back
Front
correct
Small Listening room
Advertisement
