This User Manual describes precisely how to handle your material properly and to avoid accidents. Please follow the instructions of use in order to take advantage of all C-RED One performances. Please read carefully the warnings in section 2 and follow the safety precautions in order to avoid any personal injury or damage when using the camera.
Classification: PUBLIC Disposal C-RED One’s sensor contains specific material such as Mercury and Cadmium, which are concerned by the RoHS rules. However, C-RED one is exempted from RoHS limitation, cf Annex 4.1.c., “Directive 2011/65/EU of the European Parliament and of the Council of 8 June 2011 on the restriction of the use of certain hazardous substances in electrical and electronic equipment Text with EEA relevance”.
Note 2: The softwares are available on demand. Note 3: Items may differ from pictures. Note 4: If you bought your C-RED One system together with the cooling unit, please refer to the cooling unit instructions before handling the cooling unit (see section 4 for minimum requirements).
Latency between exposure and first pixel availability µs 4.2.2. Mechanical and optical interfaces The C-RED One camera is designed to deliver the best precision possible regarding the optical alignment of the sensor. First Light Imaging SAS Europarc Ste Victoire – Bât 6.
C-RED One power connector cabling Always use the provided power supply. 4.3.2. Cooling To achieve its nominal performance, the C-RED One camera requires liquid cooling. The camera has its own internal thermal regulation that cools the detector down to 80K. Parameters...
The C-RED One firmware communicates with the user through the serial line embedded in the Camera Link® cables. Usually the driver for the Frame grabber will expose the serial line of the Camera Link®...
Issue: 002 Classification: PUBLIC Note: Some cameras don’t have a valve. If you are in this case, please contact First Light Imaging at contact@first-light.fr. Also, firmware before release 2.0.0 were more restrictive: the poor vacuum was 10-4 mb and the faulty vacuum 10-3 mb.
The sensor can finally be seen as an array of 10 x 256 blocks of 32 pixels. 6.4.1. Pixel format C-RED One digitizes the signal from the sensor with 16-bit precision. The pixel values are in unsigned format and range from 0 to 65535 ADUs.
Page 23
Europarc Ste Victoire – Bât 6. Route de Valbrillant Le Canet 13590 MEYREUIL FRANCE +33 (0)4 42 61 29 20 First Light Imaging SAS au Capital de 85 000 euros 533 716 817 RCS Aix-en-Provence TVA : FR78 533 716 817...
Page 24
Europarc Ste Victoire – Bât 6. Route de Valbrillant Le Canet 13590 MEYREUIL FRANCE +33 (0)4 42 61 29 20 First Light Imaging SAS au Capital de 85 000 euros 533 716 817 RCS Aix-en-Provence TVA : FR78 533 716 817...
Classification: PUBLIC Camera Link® data format C-RED One uses the Camera Link® Full interface that requires two data cables. Data are transmitted with a standard protocol using 4 taps of 16 bits width. With this configuration, pixels are sent 4 by 4 through the Camera Link® and the Camera Link® Pixel Clock will be at 80MHz.
6.5.2. Issuing commands to the camera – How to C-RED One firmware communicates with the user through the serial line embedded in the Camera Link® cables. Usually the driver for the frame grabber will expose the serial line of the Camera Link® standard as a virtual COM port on the acquisition system.
Failing to provide external water cooling may damage permanently the camera. 6.6.2. Adjusting Frame rate / Exposure To change the rate at which C-RED One acquires images, the camera must be issued an ‘fps’ command. Syntax is ‘set fps ’ where is the requested speed in frames per second.
The maximum speed is twice lower than the maximum frame rate in single read mode. Correlated Double Sampling mode C-RED One can deliver raw frames or the processed one every two frames by selecting the parameter “Raw” or not. First Light Imaging SAS Europarc Ste Victoire –...
It’s a burst mode. Correlated Double Sampling mode. C-RED One can deliver raw frames or the result of the subtract of the last frame minus the second one by selecting the parameter “Raw” or not.
Classification: PUBLIC Synchronization 7.3.1. Cable Assembly Together with the C-RED One Camera with synchronization option are supplied 2 LEMO cables (FGG.00. 304.CLAD35). These cables will allow you to use all the functionalities of the Synchro card. Wiring is detailed below:...
Classification: PUBLIC 7.3.2. Synchro connection C-RED One with Synchro Mode offers the possibility to drive the frame readout with an external trigger and can provide timing information through a 4-pin LEMO connector (Mating LEMO male connector reference is FGG.00.304. series connectors).
7.3.4. Output : FVAL This output delivers a signal synchronized with each new image delivered by C-RED One. The sync out is the mirroring of the FVAL (frame valid) Camera Link® signal. It indicates when data is available on the bus and reflects the camera frame rate.
Europarc Ste Victoire – Bât 6. Route de Valbrillant Le Canet 13590 MEYREUIL FRANCE +33 (0)4 42 61 29 20 First Light Imaging SAS au Capital de 85 000 euros 533 716 817 RCS Aix-en-Provence TVA : FR78 533 716 817...
Page 40
Europarc Ste Victoire – Bât 6. Route de Valbrillant Le Canet 13590 MEYREUIL FRANCE +33 (0)4 42 61 29 20 First Light Imaging SAS au Capital de 85 000 euros 533 716 817 RCS Aix-en-Provence TVA : FR78 533 716 817...
Page 41
- locked: A critical error occurred, the camera s in safe mode and locked. It means you can’t use it anymore. You have to contact First Light support to restart the camera. status detailed Get last status change reason (if available) continue Continue camera starting.
Page 42
Europarc Ste Victoire – Bât 6. Route de Valbrillant Le Canet 13590 MEYREUIL FRANCE +33 (0)4 42 61 29 20 First Light Imaging SAS au Capital de 85 000 euros 533 716 817 RCS Aix-en-Provence TVA : FR78 533 716 817...
Please use your cooling system in accordance to the cooling system instructions. Dew point: even if C-RED One is hermetically sealed and not subject to dew issue, please use cooling fluid at a temperature not below the dew point, do not use a coolant fluid temperature below the ambient temperature.
Need help?
Do you have a question about the C-RED One and is the answer not in the manual?
Questions and answers