Wireless Wan - Panasonic FZ-M1 Series User Manual

Wireless WAN

<Only for model with wireless WAN>
This computer is equipped with the Wireless WAN enabling you to communicate using radio frequencies.
N O T E
Communication is established through the Wireless WAN antenna (A). Do not block the antenna area with

your hand or body.
To use wireless WAN, set

[Advanced] menu of the Setup Utility.
Before the computer enters sleep or hibernation, cut the Wireless WAN communication. Entering sleep or

hibernation without cutting the connection may disable communication after resuming. In this case,
restart the computer.
If "Device driver software was not successfully installed" (or a similar message) appears when starting

the computer or resuming from sleep or hibernation.
When communication works normally, Wireless WAN is operating correctly.
If communication fails, the device may not be recognized correctly. In this case, restart the computer.
Do not use the microSIM card adapter.

Do not insert microSIM cards on which labels or stickers are affixed. Failure to obey may result in

malfunction.
Inserting/Removing a microSIM Card
Before using the Wireless WAN, set a microSIM card to the microSIM card slot.
CAUTIO N
Be sure to turn off the computer before inserting or removing the microSIM card.

To insert a microSIM card
1. Turn off the computer.
2. Disconnect the AC adaptor, remove the battery pack. (
3. Open the cover (A).
[Wireless WAN] of [Wireless Configuration] to [Enabled] (default) in the
Remove the Battery Pack)