Table of Contents
Advertisement
Quick Links
Download this manual
See also:
Instruction Manual
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for RadioLink F110S
Summary of Contents for RadioLink F110S
- Page 1 Radiolink Electronic Limited www.radiolink.com RadioLink Micro Racing Drone F110S by Inertial Navigation) (Altitude Hold User Manual Radiolink Electronic Limited www.radiolink.com...
- Page 2 Introduction Thank you for purchasing Radiolink mini racing drone -- F110S. In order to fully enjoy the benefits of this racing drone and ensure flight safety, please read the instructions carefully and set up the device as described below, when we write this instruction, we try our best to use the familiar and simple words to make it easy for beginners to understand the name and formulation.
-
Page 3: Table Of Contents
3.4 How to Disarm..........................7 3.5 How to Arm..........................8 4. Low Voltage alarm..........................8 5. Flight Controller CS360 Introduction....................9 6. Read Before Use F110S........................9 6.1 Read Before Start to Flight......................9 6.2 Read Before try the Throw and Fly Mode...................9 7. Flight Mode............................9 7.1 Altitude Hold Mode (Low-speed) ....................9... -
Page 4: Features Highlights
2. Compatible with Remote Controllers F110S compatible with RadioLink remote controllers AT10, AT10II, AT9, AT9S and T8FB. F110S will sell with receiver R6DSM or R8FM (you can buy F110S with R6DSM or F110 with R8FM from our dealer). R6DSM compatible with RadioLink remote controllers AT10, AT10II, AT9, AT9S. -
Page 5: Preparing Before Flight
RadioLink remote controller 3. Preparing Before Flight 3.1 Charge First, please keep your battery is 4.2V to ensure your F110S with enough power to fly, you can charge your battery by CM120 if not fully charged. Professional Designed LiPo Battery Charger CM120 Energy Supply Station Brand new designed LiPo battery charger CM120, designed for 1S LiPo battery. - Page 6 T8FB user manual (you can download from our website www.radiolink.com). T8FB: SwB at the up position means that F110S will flight in Altitude Hold Mode (Low-speed) and at the center position means that F110S will flight in Altitude Hold Mode (High-speed), if SwB at the...
-
Page 7: Power On And Bind
CS360(like the picture), make sure before power F110S on. (2) Please put the F110S on a level surface, the green LED will blink after power on about 2 seconds, do not move F110S when green LED blinking. -
Page 8: How To Disarm
12CH to 10CH in SYSTEM menu because R6DSM is a 10 channels receiver. (AT9, AT9S and AT10 are the same) F110S now just support S-BUS signal, both R6DSM and R8FM support S-BUS and PPM signal, please make sure that the LED of R6DSM/R8FM is blue which shows R6DSM/R8FM output S-BUS signals. -
Page 9: How To Arm
Move the throttle stick to the lower position and rudder stick, keep about 2 seconds till green LED off. Arm Gesture 4. Low Voltage Alarm The green LED of flight controller CS360 is blinking all the time indicate that the voltage of F110S... -
Page 10: Flight Controller Cs360 Introduction
(3) Let the motor be perpendicular to F110S plate. 6.2 Read Before try the Throw and Fly Mode (1) Make sure you can control F110S skillful and at a pretty wide-open space to try the Throw and Fly Mode. (2) Make sure the head direction and then throw and fly the F110S. -
Page 11: Altitude Hold Mode (High-Speed)
Level calibration have finished when you received the F110S, you can re-calibrate if you need. Level Calibration: Please put the F110S on a level surface, the left stick to the lower left position and the right stick to the lower right position, keep about 3 seconds, the green LED will blink once, then calibrate success. -
Page 12: Details About Fpv
Radiolink Electronic Limited www.radiolink.com 10. Details about FPV...
Need help?
Do you have a question about the F110S and is the answer not in the manual?
Questions and answers