Advertisement
Quick Links
For Models
Communication
For use with all Panasonic KSUs with
door phone card.
Installer furnishes his own KX-T30865 door
phone and attaches to Holovision plate with
bracket which is supplied.
To Panasonic
KSU
Manual Type 1.1.0.2-RF
KX-T 30865 With 265 Controller
101
103
201
Specifications
Access Control
Essex 265 controller
2 relays
5-6 users
16.5 VAC power supply included
R
T
Door bell button
See assembly note on page 7
203
301
302
Front View
KX-T30865
INSTALLATION
INSTRUCTIONS
501 E. Goetz Ave.
Santa Ana, Ca 92707
www.eholovision.com
Ph. 714-434-6904
Fax 800-362-0002
HOLOVISION
Advertisement
Related Manuals for HOLOVISION 101
Summary of Contents for HOLOVISION 101
- Page 1 Essex 265 controller door phone card. 2 relays 5-6 users Installer furnishes his own KX-T30865 door 16.5 VAC power supply included phone and attaches to Holovision plate with bracket which is supplied. To Panasonic Front View KX-T30865 501 E. Goetz Ave.
- Page 2 Essex Keypad Wiring Holovision Entry System with Keypad Doorphone Strike 1 Door 1 Gate To Phones Strike is recommended AC Out For Strike NC 2 NO 2 COM 2 NC 1 NO 1 COM 1 - OUT 16.5 Earth NOTE:...
- Page 3 Essex Keypad Wiring Contact Closure for Gate Operation Panasonic Compatable Door Station Holovision Entry System with Keypad To Doorphone Port on KSU Door Card “Open” Terminals on Gate Motor Relay Out KSU Door Card Essex Model 265 NC 2 NO 2 16.5 VAC...
- Page 4 Set Essex Relay Options GOAL: To use jumper pins on circuit board to configure standard relay options. In this configuation, Codes 1 and 2 operate Relay 1. Codes 3, 4, 5 operate Relay 2. Step Action Relay 1 and 2 activate. Only Relay 1 latch* Relay 1 Relay 2 Relay 1...
- Page 5 Programming of Essex Keypad GOAL: Set-up master and user codes Set Master Code Step Action Press “Program” switch once. (keypad will beep 4 times) Once “Program” switch is pressed, you have 2 minutes to complete Step 5 Press “1119”. (you will hear 3 beeps) Step 5 must be completed within 5 seconds of Step 3.
- Page 6 Programming of Essex Keypad Set User Code 5 Step Action Enter “Master Code” Enter 119 (3 beeps) Enter User Code 5. Wait 5 seconds for 3 reset beeps. Delete Any Code Step Action Enter Master Code . Enter address of code to be deleted (111, 113, etc.). Do not enter any code until you hear 3 reset beeps.
- Page 7 Programming of Essex Keypad Set Activation Time Of Relay 1 (User codes 1 & 2 - see note below) Step Action Press “Program” switch (keypad will beep 4 times) Enter 1117 (3 beeps) Enter 1 for every 1 second latch time, and 5 for every 5 seconds. Examples 6 seconds = 5, 1 8 seconds = 5, 1, 1, 1...
- Page 8 501 E. Goetz Ave. Santa Ana, Ca 92707 Ph. 714-434-6904 Fax 800-362-0002 www.eholovision.com...