Playback Scenes & Chases - TECshow NAVIGATOR 3 User Manual

Note: LCD DISPLAY will shoe the number of the step
in the Chase nos the Scene bank/number.
Auto run scenes
This function will run a bank of programmed scenes
in a sequential loop.
1. Press the AUTO/DEL BUTTON (8) to activate
the Auto Mode. A flashing light in the LCD DIS-
PLAY (3) will indicate Auto Mode.
2. Use the UP and DOWN BANK BUTTONS (4), to
select a bank of scenes to run.
3. After selecting the bank of scenes you want
run, you can use the SPEED (13) and FADE (12)
faders to adjust the scene chase.
Note: You can change banks to run different scene
sequences, at any time by pressing the UP and
DOWN BANK BUTTONS (4).
When Adjusting fade time never make it slower than
the Speed setting or your scene will not be com-
pleted before a new step is sent.
9. PLAYBACK SCENES & CHASES
Run scenes via sound active
1. Press the AUDIO/BANK-COPY BUTTON (9)
to turn on the corresponding LED in the LCD
DISPLAY (3).
2. Select the bank that holds the scenes you wish
to chase by using UP or DOWN BUTTONS (4),
you may also use a MIDI controller to change
the scenes (see MIDI operation).
3. Press AUDIO/BANK COPY BUTTON (9) to exit.
Run chases via sound active
1. Select your desired chase by pressing one of
the six CHASE BUTTONS (5).
2. Press and release the AUDIO/BANK-COPY BUT-
TON (9).
3. The corresponding LED will flash in the LCD
P. 10
Tecshow Navigator 3 |
English version
Auto run chases
1. Select your desired chase by pressing any or all
of the six CHASE BUTTONS (5).
2. Press and release the AUTO/DEL BUTTON (8).
3. The corresponding LED will flash in the LCD
DISPLAY (3) indicating Auto Mode is engaged.
4. Adjust the SPEED (13) and FADE (12) times to
your desired settings.
5. The chase will now run according to your set
speed and fade time.
Note: You can override the speed and by tapping
the TAP SYNC/DISPLAY BUTTON (11) three times,
the chase would then run according to the time
interval of your taps.
When Adjusting fade time never make it slower than
the Speed setting or your scenes will not be com-
pleted before a new step is sent.
If you want to include all the Chases, press the
AUTO/DEL BUTTON (8) before selecting Chase.
DISPLAY (3) indicating Music mode is engaged.
4. Chase will now run sound.
Adjust the sound sensitivity
1. Press the AUDIO/BANK-COPY BUTTON (9)
to turn on the corresponding LED in the LCD
DISPLAY (3).
2. Press and hold the AUDIO/BANK-COPY BUT-
TON (9) and use the UP and DOWN BANK BUT-
TONS (4) to adjust the sound sensitivity