AIR SYSTEMS TA-3 Operating Manual page 5

PLASTIC COWL
SteP 1)
Remove the outlet fitting from the compressor.
SteP 2)
Remove the black plastic cowl from the air end by pulling firmly.
SteP 3)
Remove the foam air filter and clean or replace. If filter is in good condition it can be cleaned with a mild detergent and
water.
SteP 4)
With filter removed, clean inside of plastic cowl and separator casing.
SteP 5)
There are 2 styles of air filters used on these compressors. A donut style filter that slides over the air end and is not held
in place by retaining clips (new style) and a strip filter that is held in place by retaining clips (old style). If you receive the
donut style filter and you have the retaining clips on your air end, simply cut the donut filter so it will wrap around the sep-
arator casing and the ends of the filter will be held in place by the retaining clips.
rePlAcement oF Air intAKe Filter
AIR INTAKE FILTER
SEPARATOR CASING
RETAINING CLIP
rePlAcement oF oil SePArAtor element
5
SteP 1)
Remove retaining screws (A).
SteP 2)
Gently tap the end cover (B) until it is clear of the
separator casing.
SteP 3)
Unscrew the oil separator element (C) and discard.
SteP 4)
Install a new separator element (P/N COMPA022).
Ensure that the o-ring (E) is in place. Do not over-
tighten.
SteP 5)
Refit end cover (B). Ensure cover is positioned
correctly and bolt holes are in line. Be careful not to
damage o-ring (D) when refitting.
SteP 6)
Refit cap screws (A) and tighten between 4-6.8 Nm
(3-5 ft./lbs.)