Oil Change Procedure; Sight Glass; Oil Cooler - AIR SYSTEMS TA-3 Operating Manual

SIGHT GLASS

WASHER (P/N COMPA043)
FILL PLUG (P/N COMPA042)
SteP 1)
View pressure gauge to insure there is no pressure in compressor body.
SteP 2)
Remove filler plug/dipstick and gasket. (replace gasket if necessary)
SteP 3)
Position a suitable container underneath compressor and remove drain plug and gasket. (replace gasket if necessary)
SteP 4)
When oil is finished draining, reinstall the drain plug and gasket.
SteP 5)
Fill compressor with factory approved oil. Use Air Systems part no. HP-268 (approximately .8 liters). Oil should reach the
bottom threads of the filler plug/dipstick or just to the top of the sight glass. DO NOT OVERFILL!
SteP 6)
Reinstall the filler plug/dipstick and gasket. Tighten to approximately 25Nm (18.5 ft./lbs.)
SteP 7)
Run compressor for approximately 10 seconds, turn off, recheck oil level, and add if necessary.

oil cHAnGe ProceDUre

oil cooler

Blow dust off of oil cooler periodically to prevent over-heating.
4
FILLER PLUG (P/N COMPA040)
FILLER PLUG (P/N COMPA040)