Getting Started; Using The Sim Card/Battery; Charging The Battery - Siemens A65 User Manual

8

Getting started

Getting started

Using the SIM card/battery

Your phone's display is delivered with a
protective film. Remove this film before get-
ting started. To avoid damage to the dis-
play, the phone should not be used with-
out the front cover. The service provider
supplies you with a SIM card on which all
the important data for your account is
stored. If the SIM card is credit card-sized,
snap out the smaller segment and trim
any rough edges.
Remove the battery cover upwards
1
2
Insert SIM card
the locating slot (make sure the angled
corner is in the correct position
push the retaining catch over the top of
4
the SIM card .
4
Insert the battery sideways into the
5
phone , then press downwards
until it engages.
1
and push it fully into
3
). Then
2
3
6
To remove, press the retaining tab
then lift the battery out.
Insert the battery cover by the tabs at the
8
bottom
until it engages.
.
Always switch off phone before removing
the battery!
Only 3V SIM cards are supported. Please
contact your service provider if you have
an older card.
Functions without SIM card p. 10.

Charging the battery

The battery is not supplied fully charged.
Plug the charger cable into the bottom of
the phone, plug the power supply unit
into a mains power socket and charge for
at least two hours. The power supply unit
will become hot after extended use. This
is normal and is not dangerous.
6
7
, then press downwards
9
8
5
7
9
,