Amerec T100 Mounting Template

Touch control
Hide thumbs Also See for T100:

Advertisement

T100 MOUNTING TEMPLATE
NOTE: If you are printing these instructions, make sure acrobat's print scaling is set to NONE.
Measure your printed instructions to ensure they are printed to the correct scale before use as a template!
Step1: Drill four 3/4" holes spaced as shown below.
Hole pattern must be level and plumb as shown.
2-5/8"
(67mm)
3/4"
(19mm)
" 5
" 5
(127mm)
(127mm)
2-5/8"
(67mm)
4211-xxx 07-29-11

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the T100 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Amerec T100

  • Page 1 T100 MOUNTING TEMPLATE NOTE: If you are printing these instructions, make sure acrobat's print scaling is set to NONE. Measure your printed instructions to ensure they are printed to the correct scale before use as a template! Step1: Drill four 3/4" holes spaced as shown below.
  • Page 2 T100 MOUNTING TEMPLATE NOTE: If you are printing these instructions, make sure acrobat's print scaling is set to NONE. Measure your printed instructions to ensure they are printed to the correct scale! before use as a template! Step2: Cut straight edges from hole to hole as shown.

Table of Contents