Main Panel; In/Out; Depth; Remote - Eventide PS101 Instruction Manual

2.5 Main Panel

In/Out

Depth

Remote

Oscillator

Manual Knob

Threshold

Release

Mod Source

Bypasses the plug-in. Out for bypass, In for wet output.
Controls the mix of wet and dry signals. At 0% the output is
solely the phase shifted signal. At 100% the output is the ad-
dition of the phase shifted signal and the input. This will cause
a gain of 6dB at certain frequencies depending on the phase
shift.
Enables MIDI CC1 (Mod Wheel) control of the phase shift. Note
that this must be set to 'On' AND the Mod Source must be set
to 'Remote'.
Controls the rate of the LFO. Ranges from 0.01Hz to 20Hz when
un-synced, 16 bars to
Provides manual control of phasing. 0% moves the nulls in
the frequency response to their highest position in frequency,
100% moves them to their lowest position in frequency.
Controls the threshold of the envelope follower. This is variable
from -30dB to -0dB. An input signal at this level will result in the
biggest change in phase shift when using the envelope follower
phase shift control.
Sets the release time of the envelope follower. Release times
can vary from 10 milliseconds to 10 seconds.
The Mod Source knob sets which control signal is used to vary
the phase shifting. This can be one of: Manual, Oscillator, Re-
mote (MIDI), or Envelope Follower.
6
1
note when synced.
64