Panamax BlueBOLT MD2-ZB Installation Instructions

OPVIONS !FO 0 11\~G & FRONT COVER FACEPLATE
Cover of MD2-ZB can easily be removed by
pulling off cover at the two side indents (1).
n
1
Unit can be securely screwed into wall outlet
faceplate using either hole (2) indicated (screw
is included).
IONS
Electrical Ratings
Line Voltage _ _ 120 Vac, 60Hz
Current Rating _ _ 12 A
Voltage Protection Rating (UL 1449 3rd Edition,
3,000A) 400V L-N, 600V L-G,
500V N-G
Nominal Discharge Current
(UL 1449 3rd Edition_ 3,000A
Electrical Measurements
RMS Voltage ___ 1 % precision
RMS Current ___ 1 % precision
Power 2% precision
Cumulative Energy_ 2% precision
CCSAUS Certified: UL 1449 3rd Edition
(Type 3 SPD), CSA C22.2 No. 42
UL 1449 Voltage Protection Rating:
400V L-N, 600V L-G, 500V N-G
c®" u s
Cover can be removed & painted to match color
of wall. Do not paint the sides, top or bottom.
Warranty will be voided.
RF I ZigBee®
ZigBee®/802.15.4 Radio
2.405-2.475 GHz, unlicensed ISM band
3dBm transmitter output
-99dBm receiver sensitivity
General
Weight 0.71b
Dimensions 3.25 in. W X 1.625 in.
D X 5.25 in. H
ZigBee is a registered trademark of ZigBee Alliance, Inc.
Product Warranty: Limited 3 Year Warranty
Connected Equipment Protection Policy:
Limited $100,000
Connected Equipment Policy
INSTALLATION INSTRUCTIONS MD2-ZB
POWER STATUS INDICATOR LIGHTS
Outlet 1
Network
OUTLET 1
Left side.
Ground Pin Out.
REMOVABLE COVER
FACEPLATE
Finger Indent to Pull Off
Cover.
This device complies with part 15
of the FCC Rules. Operation is subject
to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
PUSH BUTTONS
For Outlet's Power ON/OFF and Network Connection
INDICATOR LIGHTS
• • -. Outlet2
.-._.,.._,_.,.. _ _ _ _ _ _ Wiring Fault
r
r
OUTLET2
Right side.
Ground Pin Down.
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device in
accordance with the specifications of Part 15 of FCC rules. These specifications are designed to
provide reasonable protection against such interference win a residential installation.
However, there is no guarantee that interference will not occur in a particular installation.
In accordance with FCC 15.21, changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
DIN-00019 8/12