Renewal Parts - GE IAC66K Instructions Manual

The tap screw is the screw holding the right-hand stationary contact of the seal-in unit.
first
the tap setting,
in
and place it the desired tap.
contact. This procedure is necessary to prevent the right-hand stationary contact from getting out of adjust­
ment. Screws should not be in both taps at the same time.
It is recommended that sufficient quantities of renewal parts be carried in stock to enable the prompt
replacement of any that are worn, broken, or damaged.
When ordering renewal parts, address the nearest Sales Office of the General Electric Company, specify
quantity required, name of the part wanted, and the complete model number of the relay for which the part is
required.
remove the connecting plug.
Next, remove the screw from the other tap, and place it in the left-hand
GEI-44233
Then, take a screw from the left-hand stationary contact

RENEWAL PARTS

10
To change